Until now, slitting glass fiber rolls was either too expensive for the average shop, or too cumbersome for the average laminator. Slitting rolls of glass fiber by conventional saws left uneven, frayed edges. More expensive machines mandate the purchase of expensive mandrels for every different diameter cardboard core. Unless you slit multiple pallets of glass per day, it just was not feasible. The SWISCUT 700 is an ingenious design that does not rotate the glass, but slices through the glass with precision ground blades that reciprocate in opposing direction to gently shear though the glass and core leaving a perfect, straight edge. This designed and built in Switzerland machine is easier to use than its counterparts, and meets tough safety standards with its guard design and shut-off sensors. Its anodized hopper assembly, ground stainless adjusting shafts and ball bearing slide adjustments insure long life in the harsh fiberglass shop environment. It even has casters on one end so it can be located in different areas in your shop.....>>>>>>>>......Specifications: Floor space required 127 cm x 85 cm (4' 3" x 2'10")...Weight: 85kg - 187lbs.... Power: 1.3HP 220/440V 3 phase motor with gear reduction and adjustable amp motor starter...... Maximum Cutting Diameter: 700mm (28")..... Cycle times: 30 seconds to 2 minutes depending on roll diameter, cardboard core diameter and thickness & blade sharpness..... Cutting widths: 50mm or 2" with sharp blades

E-mail a friend about this item.